Energy UNITS FOR LIFT TABLE one
Common Description
This electrical power unit is created solely for the smaller lift table,Consisting of large stress gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This electrical power unit continues to be broadly utilized inside the business of logistic units for example minifork lift, scissors lift and ariel doing work platforms. The lower-ing movement is controlled from the solenoid valve with all the pace controlled from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Basic Description
This energy unit is developed solely for the medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve along with the velocity controlled from the adjustable needle valve. Once the lift rises to a substantial positoin, but the power provide is reduce, the decreasing motion is controlled through the guide override function.
Electrical power UNITS FOR LIFT TABLE three
General Description
This energy unit is intended exclusively for that massive lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve plus the speed managed by a strain compensated flow management valve.
Power UNITS FOR LIFT TABLE four
Common Description
This power unit is made exclusively to the huge lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve along with the pace managed through the adjustable needle valve. Once the lift rises to a higher positoin, but the energy supply is reduce, the reducing motion is managed by the manual override function.
Unique Notes
1. This electrical power unit is of S3 duty cycle, which could only work intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean the many hydraulic components concerned prior to installation of the power unit.
three. Viscosity of your oil shoud be 15~46 cst,which should really also be clean and cost-free of impurities.N46 hydraulic oil is suggested.
4. Oil shifting is required following the first one hundred operation hours,afterwards as soon as just about every 3000 hrs.
5. The energy unit proven is made to be mounted vertically.